排序方式： 共有69条查询结果，搜索用时 551 毫秒
31.
ABSTRACTTo answer the question “what has changed the surface temperatures of water bodies around Iran under climate change conditions,” Moderate Resolution Imaging Spectroradiometer (MODIS) sea surface temperature (SST) data with 9.2-km spatial resolution and monthly time step were evaluated. A significant increasing trend was obtained using Pearson’s correlation coefficient and Mann-Kendall trend test on data from the Caspian Sea (June) and the Southern Gulfs (September). High correlations of 0.69 and 0.97 between remotely sensed data and ERA-Interim reanalysis data were also obtained for June and September, respectively. To assess the impact of some climatic parameters on SST variability in those two months, zonal and meridional wind at 10 m, wind speed at 10 m, air temperature at 2 m, and mean sea level pressure were evaluated. High correlations between meridional wind and the Southern Gulf SST, and meridional wind and Caspian SST were ?0.86 and 0.75, respectively. Moreover, the results showed an important role of air temperature (0.96) and sea level pressure (?0.77) in the rising temperature trends of the Southern Gulfs. Wind speed was also detected in both regions as a booster of the trend. 相似文献
32.
In this study, a geotechnical model has been used to analyze the stability of a discontinuous rock slope. The main idea behind block theory is that it disregards many different combinations of discontinuities and directly identifies and considers critical rock blocks known as “key blocks”. The rock slope used as a case study herein is situated in the sixth phase of the gas flare site of the South Pars Gas Complex, Assalouyeh, Iran. In order to analyze the stability of discontinuous rock slopes, geotechnical modeling which was divided into geometrical sub-modeling and mechanical sub-modeling has been utilized. This model has been established upon the KGM (key-group method) algorithm which was based on the limit equilibrium method and block theory and prepared and coded by the Mathematica software. According to the results of the stability analysis, the analyzed slope was determined to be in the category of “needs attention,” and the security level, calculated through the FORM (first-order reliability method) analysis, was estimated to be 1.16. In order to verify the model, the results obtained from the model were compared with those of the UDEC software, which is a numerical method based on distinct components. As a conclusion, it was determined that the results of the model agreed well with those of the numerical method. 相似文献
33.
Nematollah Rachidnejad-Omran Mohammad Hachem Emami Mossaïeb Sabzehei Ebrahim Rastad Herv Bellon Alain Piqu 《Comptes Rendus Geoscience》2002,334(16)
A detailed analysis of metamorphic complexes outcropping in the Muteh area in central Iran leads to establish the regional stratigraphical column, and to propose a Palaeozoic age for the metamorphic protolith that mainly consists of volcano-sedimentary units. 40K---40Ar ages for minerals suggest the Mesozoic age of the metamorphic amphiboles and the Palaeocene ones for a late or even post metamorphic bimodal magmatism. To cite this article: N. Rachidnejad-Omran et al., C. R. Geoscience 334 (2002) 1185–1191. 相似文献
34.
35.
Sajjad Maghfouri Ebrahim Rastad David R. Lentz Fardin Mousivand Flavien Choulet 《Chemie der Erde / Geochemistry》2018,78(1):40-57
The southwestern Sabzevar basin is the north of Central Iranian Microcontinent hosts abundant mineral deposits, including exhalative Mn mineralization and Cu-Zn volcanogenic massive sulfide (VMS) deposits. Amongst them, the Nudeh Besshi-type Cu–Zn volcanogenic massive sulfide (VMS) deposit is hosted within the lower part of a Late Cretaceous volcano-sedimentary sequence composed of alkali olivine basalt flows and tuffaceous silty sandstone. Based on investigations into the ore geometry, mineralogy, and texture, we recognized three different ore facies: (1) a stockwork of sulfide-bearing quartz veins cutting across the footwall volcano-sedimentary rocks and representing the stringer zone; (2) a massive ore type, displaying replacement texture with pyrite, chalcopyrite, sphalerite, friedrichite, and minor magnetite; and (3) a bedded ore type, with laminated to disseminated pyrite and chalcopyrite. EPMA studies indicate a distinctive minor element distribution between the different ore types of the Nudeh deposit. The Fe content in the sphalerite ranges from 0.65–1.80?wt.%, indicating the Fe-poor nature of the sphalerite. However, the Cd content in sphalerite ranged between 0.164–0.278?wt.%. According to the mineral compositions, Zn, Se, and Ag are found in bornite as minor elements. In the bedded ore facies, the pyrite contains higher levels of Se (up to 0.35?wt.%). The Zn content in the friedrichite in all of the ore samples is low. The Co/Ni ratios in pyrite from the Nudeh ore are lower than those of most magmatic deposits, but are similar to those from volcanogenic deposits, and hence support the proposed hydrothermal origin of the deposit. Two generations of quartz, Q1 and Q2 in the stockwork veins, contain primary fluid inclusions and these contain two phases (liquid and vapor). The lack of vapor-rich inclusions or variable liquid/vapor ratios indicate that the fluids did not boil at the site of trapping. Salinity for both Q1 and Q2 fluid inclusions ranges between 2.2–6.8?wt.% eq. NaCl. Homogenization temperatures for inclusions in the Q1 and Q2 veins average at about 296?°C and are similar to the temperatures of hydrothermal fluids discharged through vents in many modern seafloor VMS deposit. The Nudeh Besshi-type VMS deposit appears to have formed on the seafloor and based on the salinity and temperature constraints from the underlying stockwork, a buoyancy plume model is proposed as a mechanism for precipitation. 相似文献
36.
Khabat Khosravi Ebrahim Nohani Edris Maroufinia Hamid Reza Pourghasemi 《Natural Hazards》2016,82(2):947-961
37.
Mohammad Khandan Bakavoli Ebrahim Haghshenas Mohsen Kamalian 《Soil Dynamics and Earthquake Engineering》2011,31(5-6):737-756
Two hilly sites were selected to study seismic site response due to topography effects. The sites were selected in a manner to be as much as possible homogenous and free of the soft soil layers effects. The hills were instrumented by nine velocimetric stations to record microtremors and the obtained data were analyzed using horizontal to vertical spectral ratios. Some standard spectral ratio tests were performed on noise as well. Then the instrumented hills were modeled (both 2D and 3D) assuming a linear elastic constitutive behavior subjected to vertically propagating SV and P Ricker wavelets. All calculations were performed in time domain using direct boundary element method. Different transfer function components, amplification patterns and spectral ratios were calculated in frequency domain. The frequency of vibration, obtained by experimental studies, is between 4 and 5 Hz for both of the hills. The spectral ratios derived by numerical simulations were compared with the observed spectral ratios. They show relatively good similarities between the results of these two methods. The frequencies of vibration derived from different methods seem to be nearly identical. The agreement in term of resonance frequency between microtremors and numerical modeling suggests that noise measurements could represent a simple, even if preliminary, tool in order to identify possible topographic amplification. 相似文献
38.
Tarek A. A. Mohammed Ekbal M. Mohamed Yaser M. Ebrahim AlShimaa A. Hafez Rabab M. E. Zamzamy 《Environmental Earth Sciences》2014,71(1):301-309
The concentrations of Ca, some essential (Fe, Zn, Mn, and Cu) and non-essential nutritive elements (Cd, Pb, and Ni) were measured in the edible parts (mantle and adductor muscles) of Tridacna maximx collected from south Quseir City (Red Sea). The general trend of metal contents of the different parts follows the order; Ca > Fe > Zn > Pb > Mn > Cu > Cd > Ni. The tissues before cooking recorded the highest average concentrations of Cu, Pb, Fe, Cd, Mn, and Ni (2.658, 5.250, 34.375, 1.464, 3.207, and 0.886 ppm, respectively) relative to tissues after cooking and the water of cooked tissues (WCT). The total cooked tissues recorded higher average contents of Zn and Ca (17.282 and 1,114.679 ppm) than the uncooked tissues. Calcium recorded the highest concentration in the ECT of adductor and mantle muscles (2,081.126 ± 177.39 and 1,893.326 ± 394.28 ppm). Mantle recorded higher concentrations of Pb, Mn, Ni, and Ca (7.489 ± 4.65, 4.241 ± 1.13, 0.980 ± 0.60, and 1,039.362 ± 177.42 ppm, respectively) than adductor muscle before cooking. Ca concentration levels in the WCT increased after cooking tissues especially in adductor muscles. This may attributed to the liberation of larger amount of calcium in ionic form in water. The clams may have intracellular regulatory mechanisms to keep their concentrations in equilibrium, subsequently; the recorded metal concentrations are in the safe limits for human consuming, where these concentrations did not exceed the clam’s capacity of regulation. 相似文献
39.
Ebrahim Ghasemi‐Nejad Alastair Ruffell Hossein Rahimpour‐Bonab Mohammed Sharifi Behzad Soltani Ebrahim Sfidari 《Geological Journal》2015,50(2):210-219
Spectral gamma ray (SGR) logs are used as stratigraphic tools in correlation, sequence stratigraphy and most recently, in clastic successions as a proxy for changes in hinterland palaeoweathering. In this study we analyse the spectral gamma ray signal recorded in two boreholes that penetrated the carbonate and evaporate‐dominated Permian–Triassic boundary (PTB) in the South Pars Gasfield (offshore Iran, Persian Gulf) in an attempt to analyse palaeoenvironmental changes from the upper Permian (Upper Dalan Formation) and lower Triassic (Lower Kangan Formation). The results are compared to lithological changes, total organic carbon (TOC) contents and published stable isotope ( δ 18O, δ 13C) results. This work is the first to consider palaeoclimatic effects on SGR logs from a carbonate/evaporate succession. While Th/U ratios compare well to isotope data (and thus a change to less arid hinterland climates from the Late Permian to the Early Triassic), Th/K ratios do not, suggesting a control not related to hinterland weathering. Furthermore, elevated Th/U ratios in the Early Triassic could reflect a global drawdown in U, rather than a more humid episode in the sediment hinterlands, with coincident changes in TOC. Previous work that used spectral gamma ray data in siliciclastic successions as a palaeoclimate proxy may not apply in carbonate/evaporate sedimentary rocks. Copyright © 2014 John Wiley & Sons, Ltd. 相似文献
40.
Stochastic Modeling Approach for the Evaluation of Backbreak due to Blasting Operations in Open Pit Mines 总被引：2，自引：0，他引：2
Backbreak is an undesirable side effect of bench blasting operations in open pit mines. A large number of parameters affect backbreak, including controllable parameters (such as blast design parameters and explosive characteristics) and uncontrollable parameters (such as rock and discontinuities properties). The complexity of the backbreak phenomenon and the uncertainty in terms of the impact of various parameters makes its prediction very difficult. The aim of this paper is to determine the suitability of the stochastic modeling approach for the prediction of backbreak and to assess the influence of controllable parameters on the phenomenon. To achieve this, a database containing actual measured backbreak occurrences and the major effective controllable parameters on backbreak (i.e., burden, spacing, stemming length, powder factor, and geometric stiffness ratio) was created from 175 blasting events in the Sungun copper mine, Iran. From this database, first, a new site-specific empirical equation for predicting backbreak was developed using multiple regression analysis. Then, the backbreak phenomenon was simulated by the Monte Carlo (MC) method. The results reveal that stochastic modeling is a good means of modeling and evaluating the effects of the variability of blasting parameters on backbreak. Thus, the developed model is suitable for practical use in the Sungun copper mine. Finally, a sensitivity analysis showed that stemming length is the most important parameter in controlling backbreak. 相似文献